Derbi Rambla 250 Manual page 97

Engine
Refitting the wheel axle bearing
- Support the hub cover on a wooden surface.
- warm the cover crankcase with the specific heat
gun.
- Fit the wheel shaft bearing with a modular punch
as shown in the figure.
- Fit the seeger ring.
- Fit the oil guard with its sealing lip facing the hub
internal side and place it flush with the internal
surface using the specific tool used on the 52-mm
side.
The 52-mm side of the adaptor should face the
bearing.
Specific tooling
020376Y Adapter handle
020360Y 52 x 55-mm adaptor
020483Y 30 mm guide
ENG - 97