Suspensions
Rest the scooter on its centre stand.
•
Place a support under the chassis.
•
Remove the brake calliper.
•
Loosen the pin locking screw.
CAUTION
UPON REMOVING/REFITTING, PAY ATTENTION NOT TO
DAMAGE THE BRAKE HOSES, DISCS AND PADS.
•
Unscrew and remove the wheel pin.
•
Collect the spacers from the wheel left
and right sides.
•
Remove the wheel.
CAUTION
DO NOT ACTUATE ON THE FRONT BRAKE LEVER AFTER REMOVING THE WHEEL, OTHER-
WISE THE CALLIPER PLUNGER COULD GO OUT OF ITS SEAT, RESULTING IN BRAKE FLUID
LEAKAGE.
•
Remove the front wheel.
•
Clean the two sides of the hub with a
cloth.
•
Remove the right oil seal «1».
•
Remove the right bearing «2» with a
suitable extractor.
•
Remove the left oil seal «3».
•
Remove the left bearing «4» with a
suitable extractor.
•
Carry out a thorough check of the bear-
ings.
•
Collect the internal spacer «5».
•
Clean the inside of the hub thoroughly.
•
Wash all the parts with clean deter-
gent.
CAUTION
UPON REFITTING, USE A BUFFER WITH A DIAMETER
EQUAL TO THE EXTERNAL RING OF THE BEARINGS TO
SUSP - 189