Removing The Driven Pulley - Derbi Rambla 250 Manual

Engine
Baffle roller
Plastic roller
- Check that the roller shows no signs of abnormal
wear and that it rotates freely.
- Remove the special fixing screws as indicated in
the photograph
- Check the roller outside diameter does not have
defects that could jeopardise belt functioning
- For refitting, place the roller with the belt contain-
ment edge on the engine crankcase side
- Tighten the screw to the prescribed torque.
Locking torques (N*m)
Belt support roller screw 11÷13 (8.1÷9.6 ftlb)

Removing the driven pulley

- Remove the clutch bell and the entire driven pul-
ley assembly.
NOTE
THE ASSEMBLY CAN ALSO BE REMOVED EVEN IF THE
DRIVING PULLEY IS MOUNTED.
ENG - 82