Automatic Transmission; Transmission Cover; Specific Tooling - Derbi Rambla 250 Manual

Engine
This section describes the operations to be carried out on the engine and the tools required.

Automatic transmission

Transmission cover

- To remove the transmission cover, it is necessary
to remove the plastic cover first by inserting a
screwdriver in the slotted holes. Using the clutch
bell lock wrench shown in the figure, remove the
driven pulley shaft lock-nut and washer.

Specific tooling

AP8140661 Lock wrench for clutch bell
- Pull out the cap/dipstick from the engine oil filling
tube.
- Remove the 10 screws.
- Now remove the transmission cover.
NOTE
WHEN REMOVING THE TRANSMISSION COVER, BE
CAREFUL NOT TO DROP THE CLUTCH BELL.
Air duct
- Remove the transmission compartment air intake
cover shown in the photograph.
ENG - 80