Removing The Driven Pulley Shaft Bearing - Derbi Rambla 250 Manual

Engine
- Remove the 5 screws on the two different levels,
as well as the small casing.

Removing the driven pulley shaft bearing

- Remove the seeger ring from the inside of the
cover.
- Remove the bearing from the crankcase.
Specific tooling
020376Y Adapter handle
020375Y 28x30 mm punch
020412Y Clutch oil seal punch D 15 mm
Refitting the driven pulley shaft bearing
- Slightly heat the crankcase internal side so as not
to damage the coated surface.
- Insert the bearing in its housing.
- Refit the seeger ring.
CAUTION
REST THE COVER ON A SUITABLE SURFACE TO AVOID
DAMAGING THE COVER COAT.
NOTE
ALWAYS REPLACE THE BEARING WITH A NEW ONE AT
EVERY REFIT
Specific tooling
020376Y Adapter handle
020357Y 32x35 mm punch
020412Y Clutch oil seal punch D 15 mm
ENG - 81