SERVICE MANUAL
10
Replacing the holding strap
10.1
Standard seat & Flex II
Requirements:
open-ended spanner, 13 mm
5 mm Allen key
Note
A nut is fixed between the two washers (2) and (4) as a spacer so that the belt mounting can
rotate freely.
Remove the plastic cap (5).
Loosen the bolt (3) and the associated
nut (in the figure this is covered by the
plastic cap) with a 5 mm Allen key and a
13 mm socket spanner.
Remove the nut.
Remove the bolt including safety belt and
flat washers (2) and (4).
Remove the flat washers (4).
Replace the safety belt (1).
Refit the parts in the reverse order.
92
®
Invacare
- Bora