Invacare Spectra XTR Service Manual page 13

®
Invacare - Bora
ATTENTION!
Fire and burn hazard due to electrical short-circuit!
 The mobility device must be completely switched off before removal of voltage-carrying
components! To do this, remove the batteries.
 Avoid short-circuiting the contacts when carrying out measurements on voltage-carrying
components!
CAUTION!
Danger of burns from hot surfaces on the motor!
 Allow the motors to cool down before commencing work on them.
ATTENTION!
Injury hazard and danger of damage to vehicle due to improper or incomplete
maintenance work!
 Use only undamaged tools in good condition.
 Some moving parts are mounted in sockets with PTFE coating (Teflon™). Never grease
these sockets!
 Never use "normal" nuts instead of self-locking nuts.
 Always use correctly-dimensioned washers and spacers
 When reassembling, always replace any cable ties which were cut during dismantling.
 After completing your work / before renewed start-up of the mobility device, check all
connections for tight fitting.
 After completing your work / before renewed start-up of the mobility device, check all parts for
correct locking.
 Only operate the vehicle with the approved tyre pressures (see technical data).
 Check all electrical components for correct function. Please note that incorrect polarity can
result in damage to the electronics.
 Always carry out a trial run at the end of your work.
CAUTION!
Danger of injury and damage to property, if the maximum speed reduction on a
wheelchair with a lifter does not function correctly!
The wheelchair's control unit must reduce the maximum possible speed as soon as the lifter is
raised.
 Test the maximum speed reduction for correct function after any maintenance work or
modifications to the wheelchair.
Note
Mark all current settings for the mobility device (seat, armrests, backrest etc.), and the
associated cable connecting plugs, before dismantling. This makes reassembly easier.
All plugs are fitted with mechanical safety devices which prevent release of the connecting plugs
during operation. To release the connecting plugs the safety devices must be pressed in. When
reassembling ensure that these safety devices are correctly engaged.
SERVICE MANUAL
13