Replacing The Splash Guard - Invacare Spectra XTR Service Manual

SERVICE MANUAL
7.16

Replacing the splash guard

WARNING: Danger of crushing!
The mobility device is very heavy. Injury hazard to hands and feet!
 You should seek help from a second person.
Injury hazard caused by uncontrolled movement of the mobility device!
 Switch the power supply off (ON/OFF key).
 Engage the drive.
 Before raising the vehicle, secure the wheels by blocking them with wedges.
 Prevent the mobility device tipping by propping it up on a wooden block which is long and wide
enough under the battery case! If the wooden block is too short or too high, the mobility device
can still tip!
Requirements:

5 mm Allen key

wooden block (approx.12 x 12x 30 cm) for propping up vehicle
Note
If the splash guard is replaced, the existing motor bracket screws are reused. Ensure that the
screws are inserted in the correct position.

Remove legrests.

Release seat (1) and tilt forwards.

Disconnect the remote bus cable from the
electronics module or ACT.

Lift the seat out of the front anchorage and
remove it. When doing so, get the help of a
second person because the seat is heavy.

Remove both battery cases as described in
Chapter 7.7.1.

Undo and remove the four screws (1) & (2)
on the motor bracket which hold the splash
guard (4) using a 5 mm Allen key.

Remove the reinforcing plate (3).

Remove and replace the splash guard.
78
®
Invacare - Bora