Replacing Heel Strap; Adjusting The Legrest Angle - Invacare Action 1 NG Service Manual

SECTION 2—FRONT HANGERS

Replacing Heel Strap

NOTE: For this procedure, refer to FIGURE 2.2.
1. Remove the locking bolt (5 mm Allen key and 10 mm Spanner) that secure the
footrest tube to the footrest support.
2. Remove the lower footrest assembly.
3. Remove the mounting screw, strap pin that
secure the heel strap to the footplate.
4. Slide heel strap over footrest tube.
NOTE: When securing the heel strap to the
footrest assembly, tighten the mounting screw
and strap pin until they are secure.
5. Using the mounting screw, strap pin, secure
the heel strap to the footplate.
6. Using the locking bolt with 5 mm Allen key
and 10 mm Spanner, secure the footrest tube to
the footrest support.
7. Securely tighten (5Nm).
Adjusting Elevating Legrest Angle, Height and Calf
pad Height/Depth
NOTE: For this procedure, refer to FIGURE 2.3.
Ad justing the Legrest Angle
There are nine pre-set positions available for angle adjustment.
1. Loosening the knob and pull it up with one hand while supporting the leg rest with your
other hand.
2. Adjust into one of nine pre-set positions, downwards the knob into the desired position
and firmly tighten the knob.
3. If necessary, repeat STEPS 1-2 to adjust remaining elevating legrest angle.
Ad justing the Footplate Height
1. Unscrew locking bolt (5 mm Allen key and 10 mm Spanner).
2. Position the footrest assembly to the desired height.
Heel strap
Mounting screw
FIGURE 2.2 Replacing Heel Strap
8
Locking bolt (M6)
Strap pin