Invacare Spectra XTR Service Manual page 37

®
Invacare - Bora
Note
When disassembling, take care of small parts such as screws and washers. Put all small parts
down so that they can be reassembled in the right sequence.

Remove legrests.

Release seat (1) and tilt forwards.

Disconnect the remote bus cable from
the electronics module or ACT.

Lift the seat out of the front anchorage
and remove it. When doing so, get the
help of a second person because the
seat is heavy.

Remove both battery cases as described
in Chapter 7.7.1.

Disconnect the motor plug from the
motor to be replaced from the electronics
module.

The motor cable is secured inside the
frames with cable ties. Remove the cable
ties with the oblique pliers.

Place the vehicle upside down so that
the wheels are facing upwards. When
doing so, get the help of a second
person because the vehicle is heavy.

Heat countersunk screw TX40 (1) with
hairdryer to release screw blocker
system.

Remove the torx screw (1) with a TX40
spanner.

Pull the complete wheel off the wheel
hub.

A washer can be used to compensate the
tolerance between wheel hub and shaft
shoulder.

When replacing the countersunk screw
TX40 (1) always use a high-strength
screw blocker system such as Loctite
270!
SERVICE MANUAL
37