Canon imageRUNNER Advance C5255 Basic Operation Manual page 72

• Do not load the following types of paper into the paper deck unit. Doing so may cause a paper jam.
• Severely curled or wrinkled paper
• Thin straw paper
• Transparencies
• Paper which has been printed on using a thermal transfer printer (Do not print on the reverse side of this paper either.)
• Paper which is curled must be straightened out before loading it into the paper deck unit.
• You will not be able to make copies or print if you load paper that exceeds the loading limit mark (
is not completely pushed into the paper deck unit.
• Make sure that the height of the paper stack does not exceed the loading limit mark (
• Always check that the paper deck unit is closed.
• The paper deck unit holds up to 2,700 sheets of paper (20 lb bond (80 g/m
• Load the paper stack in stages, adding approximately 500 sheets of paper at a time. If the paper deck unit can accommodate
more paper, the lifter will descend.
• If there are instructions on the paper package about which side of the paper to load, follow those instructions.
• When the paper is loaded into the paper deck unit, the side facing down is the one printed on.
• If problems, such as poor print quality or paper jams occur, try turning the paper stack over and reloading it.
• For more information on the print direction of preprinted paper (paper which has logos or patterns already printed on it), see
e-Manual > Copy.
• Rewrap any remaining paper in its original package, and store it in a dry place, away from direct sunlight.
• If paper runs out and printing is stopped, load a new paper stack. Printing restarts after the new paper stack is loaded.
72
Basic Operation Guide: imageRUNNER ADVANCE (iRA) C5235, iRA C5240, iRA C5250, iRA C5255 - 04/2012
), or if the paper drawer
).
2
)).