Recording To A Cassette Tape - Sharp XL-HP700 Operation Manual

XL-HP700
Recording to a cassette tape
Before recording:
• When recording important selections, make a preliminary test to
ensure that the desired material is properly recorded.
• SHARP is not liable for damage or loss of your recording arising
from malfunction of this unit.
• The volume and sound controls can be adjusted with no effect on
the recorded signal (Variable Sound Monitor).
• For recording, use only normal tapes. Do not use metal or
Cr0
2
tapes.
1
Press the ON/STAND-BY button to turn the power on.
I
, 1'-1.-"-/
--, "--'0
::::,
Ie
"
,
:~~~
,-
~(-~t:
1/
II/
,.!. _
;~E,'c,/~I
1~3
I .. !.J .... ,
j
I
II ,_...... •
~I
Press the CD button and load the desired disc.
Load a cassette into the cassette compartment with side A
facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
2
6
Press one of the DISC SELECT
G) - @
(© 1 - © 3) buttons to
start recording.
• To record on both sides, begin on side A. (If recording is
started from side B, the tape will not switch over to side A.)
• Recording is started from the selected CD. When the play-
back of the last track is finished or the end of the tape is
reached, the CD and the cassette will stop automatically.
• CD playback will start approximately 7 seconds after the
tape starts.
5
Press the
e..
button.
Recording will be paused.
3
4
Press the c=) button to choose one side or both sides.
=)
To record on both sides.
=
To record on only one
side.
• Recording from a CD (CDs)
You can record the desired CD using the DISC SELECT
G) - @
(© 1
- © 3) buttons.
Side A
~"
Erase-prevention tab of cassette tapes:
• When recording on a cassette tape,
make sure that the erase-prevention
tabs are not removed. Cassettes have
removable tabs that prevent accidental
recording or erasing.
• To protect the recorded sound, remove
the tab after recording. Cover the tab
hole with adhesive tape to record on the
tape without the tab.
22