Sharp XL-HP700 Operation Manual page 18

XL-HP700
Advanced CD Playback (continued)
YES
Correct
~~
/rz\
\~-
To clear the programmed selections:
Press the CLEAR button on the remote con-
Cl Cl Cl
II
CLEAR
~~~~~i~~~~~'~U~~~i~~~~~~~;,t~~~ t ~:~~~WI· ~ ~ ~
D!TI!1ffiffiffiffii'
be cleared, beginning with the last track pro-
grammed.
To cancel the programmed play mode:
While in the stop mode and the "MEMORY" indicator is lit, press the
CLEAR button on the remote control. The "MEMORY" indicator will
disappear and all the programmed contents will be cleared.
Adding tracks to the program:
If a program has been previously stored, the "MEMORY" indicator
will be displayed. Then follow steps 1 - 6 to add tracks. The new
tracks will be stored after the last track of the original program.
To check which tracks are programmed:
While the unit is stopped in the programmed play mode, press the
~
or
~
button.
Notes:
• Opening the disc tray automatically cancels the programmed sequence.
• Even if you press the ON/STAND-BY button to enter the stand-by
mode or change the function from CD to another, the pro-
grammed selections will not be cleared.
• During program operation, random play is not possible.
• Care of compact discs
Compact discs are fairly resistant to damage, however mistracking
can occur due to an accumulation of dirt on the disc surface. Follow
the guidelines below for maximum enjoyment from your CD collec-
tion and player.
• Do not write on either side of the disc, particularly the non-label
side from which signals are read. Do not mark this surface.
• Keep your discs away from direct sunlight, heat, and excessive moisture.
• Always hold the CDs by the edges. Fingerprints, dirt, or water on
the CDs can cause noise or mistracking. If a CD is dirty or does
not play properly, clean it with a soft, dry cloth, wiping straight out
from the center, along the radius.
MEMORY/ MEMORY
ISET a
L::)
Selected disc number
~-
:=-
I I /
~~~
,_, I
Selected track number
You can also select a track by pressing the ~ or ~ button.
4
Press the MEMORY/SET (MEMO-
_li;J
n
::J
D
u
'_I
/~~~~?~~~I
RY) button to save the track
n;f
u ,_
I
U
I .
number.
6
Press the. (CD.) button.
tlf' _ __ I
The total number of memory will ap-
~gf 1' 1 11=
I'll U hi \/
1:3
MEMORY
pear.
3
Press the direct search buttons
on the remote control to select
the desired track.
2
Press one of the DISC SELECT
G)
- @
(©
1 -
©
3) buttons to select
the desired disc.
7
Press the
~
/
c:
button to start playback.
During programmed play, the DISC SELECT
G) - @
(© 1 - © 3)
buttons will not work.
5
Repeat steps 2 - 4 for other tracks. Up to 32 tracks can be
programmed.
If you make a mistake, the programmed tracks can be cleared
by pressing the CLEAR button.
1
While in the stop mode, press the
MEMORY/SET (MEMORY) button
to enter the programming save
mode.
• Programmed play
You can choose up to 32 selections for playback in the order you
like.
18