Recording To A Cassette Tape - Sharp XL-S15H Operation Manual

Recording to a cassette tape

Before recording:
! When recording important selections, make a preliminary test to
ensure that the desired material is properly recorded.
! SHARP is not liable for damage or loss of your recording arising
from malfunction of this unit.
! The volume and sound controls can be adjusted with no effect on
the recorded signal (Variable Sound Monitor).
! For recording, use only normal tapes. Do not use metal or
CrO tapes.
" Recording from a CD
1
Press the ON/STAND-BY button to turn the power on.
2
Press the FUNCTION button until "Cd dISC" appears on the
display.
When operating with the remote control, press the CD button.
3
Load the desired disc.
4
Load a cassette into the cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
5
Press the button.
6
Press the button, which also en-
gages the button.
7
Press the button again to cancel the pause mode.
8
Press the ( ) button for CD.
To perform programmed recording:
1 Programme tracks (see page 15).
2 Press the button.
3 Press the button, which also engages the
4 Press the button again to cancel the pause mode.
5 Press the ( ) button for CD.
To interrupt recording:
Press the button.
To resume recording, press the button.
To stop recording:
Press the button.
The tape will stop.
04/3/26 XL-S15H_E_3.fm
XL-S15H
1
2
3
4
5
6
7
button.
8
9
10
19
TINSEA028SJZZ