Listening To A Cd (Cds) - Sharp XL-HP700 Operation Manual

Listening to a CD (CDs)
XL-HP700
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CD button.
I
i~~~~
I
C:
lJ ,-, .
~J
CI
~~III._IUI
~
Total number of tracks on Total playing time of the
the CD whose number is CD whose number is
flashing flashing
5
Press the ~ button to close the disc tray 1.
6
You can place discs on trays 2 - 3 by following steps 3 - 5.
7 Press the ~ /
c
button to start playback.
• Playback will begin from track 1 on DISC 1. After that disc
finishes playing, the next disc will automatically play.
• When the last track on the third disc has finished playing,
the CD player will automatically stop.
• When there is no CD in one of the disc trays (1 - 3), the
empty tray will be skipped to the next tray with a CD.
To change other CDs while playing a disc:
Press the
~
button for the disc trays not in use.
To interrupt playback:
Press the CD
II
button on the remote control.
To resume playback from the same point, press the
~
c
button.
To remove the CDs:
While in the stop mode, press the desired
~
button.
To stop playback:
Press the. (CD .) button.
5 11 (12 cm) 3 11 (8 cm)
:@
:~
<$>~
4
Place the CD on the disc tray 1, label side up.
Be sure to place an 3 11 (8 cm) CD in the middle of the disc tray.
3 Press the ~ button to open the disc tray 1.
This system can also play audio CD-R and CD-RW discs, but can-
not record.
Some audio CD-R and CD-RW discs may not be playable due to the
state of disc or the device that was used for recording.
15