Bc10 Display Settings; Bc10 Display Codes - Buderus Logamax plus GB162-80 kW Installation Instructions Manual

13
Display information

13.4 BC10 Display settings

Display
Meaning of display setting
setting
Sea level (0-4,000 ft.):
configured target load (GB162-80 kW)
Sea level (0-4,000 ft.
configured target load (GB162-100 kW)
Configured target value of the pump
run-over time.
NOTE: Do not set the pump run-over
time to less than
DHW flow operating condition setting.
NOTE: If the setting
the frost protection of the DHW flow has
also been switched off.
Tab. 22 BC10 Display settings

13.5 BC10 Display codes

The following table contains all codes that can show on
the BC10 display. To show the current display code
and/or sub code, press the
3 main code groups:
• Operating codes - this code gives the status of the
boiler. No action is necessary.
• Locking faults - the boiler resumes normal operation
when the fault has cleared.
• Blocking faults - the boiler is locked and will only restart
after a manual reset. The pump will operate
continuously for frost protection.
If a blinking code is displayed together with other codes,
all displayed codes will blink.
A locking code will always show on the first screen of the
BC10.
58
Display readings
Unit Range
%
%
min.
(= 5 minutes).
is displayed,
-
e
-key repeatedly. There are
Logamax plus GB162- 80/100 kW - Subject to modifications resulting from technical improvements!
/
-
/
-
/
-
/
"Off"
Factory-adjusted
setting
100%
100%
100%
100%