Ricoh B234 Service Manual page 1065

DETAILS
3.7 FEED-OUT
[G] [D]
[A]
[B]
[E]
[H]
[C]
[F]
B830D920.WMF
[I]
B830D512.WMF
After the copies have been stapled, the stack feed-out motor [A] starts.
The pawl [B] on the stack feed-out belt [C] transports the set of stapled copies up
and feeds it to the shift tray exit roller [D].
When stapling starts, the exit guide motor [E] opens the upper exit guide [F], which
includes the upper shift tray exit roller [G], in order to feed out the leading edge of
the copy set smoothly.
The exit guide motor turns on again at the prescribed time after stapling finishes,
and the upper exit guide plate is lowered. Then the shift tray exit roller takes over
the stack feed-out.
The on-off timing of the exit guide motor is detected by the exit guide open sensor
[H].
The stack-feed-out motor turns off when the pawl actuates the stack feed-out belt
home position sensor [I].
B830 50 SM