Cover Replacement - IBM eserver pSeries 690 Installation Manual

17. Install the UEPO switch:
|
|

Cover Replacement

Refer to 107 while performing this task.
1. Examine the bottom of the frame side. There will be (2) "U" brackets installed at the
2. Always install the left side cover first.
3. Lift the cover and engage the slot into the "U" bracket, holding the cover at about a
4. Install the top (3) screws (P/N 54G2882). The use of a step ladder is recommended
5. Install the (2) inside screws and washers (P/N's 77G0599 and 1625437).
6. Install the right side cover into the "U" bracket while holding it an angle away from
7. Since the right side cover has tab features that engage behind the left side cover,
8. Repeat steps 4 and 5.
126
pSeries 690 Installation Guide
v Install the top and bottom screws. Screws should be bottomed against the end
of the slot prior to tightening.
v Plug in the cables.
bottom. These correspond to open slots in the bottom of the covers.
30 degree angle with the top away from the frame.
for this procedure. Push against the top of the cover to compress the gasketing to
allow alignment with the tapped holes in the top of the frame.
the frame.
the cover must be rocked to the right from the top to clear the left side cover. After
clearing the cover with the tabs, push the cover against the frame while rocking it
back to the left. The cover should rest on the "U" bracket. The top flange should
rest on the frame and the tabs should bepositioned behind the left hand cover.
Note: The covers should be flush in the middle with a small gap between them.