IBM eserver pSeries 690 Installation Manual page 134

Hide thumbs Also See for eserver pSeries 690:
Table of Contents

Advertisement

__ Step a. Remove the two screws at the left and right of the top frame side
__ Step b. Lift off the covers.
__ Step c. Remove the eight screws around the perimeter of the top panels at the
__ Step d. Carefully note the orientation and position of the foam and metal upright
__ Step e. Remove the single screw at each end of the cross brace (item 5 in the
__ Step f. Remove the two screws at the front of the left BPE rail and remove the
__ Step g. Remove the two screws at the rear of the right BPE rail and remove the
3
118
pSeries 690 Installation Guide
covers (items 7 and 8 in the illustration on 112).
front and rear of the rack top frame assembly. Remove the two top
panels (item 1 in illustration in the illustration on page 117).
air baffle (item 4 in the illustration on page 117) at the middle left side of
the rack top frame assembly. Remove the screw, then tilt the baffle
toward the front of the rack top frame.
Note: The foam and metal upright air baffle must be reinstalled on the
left side in their original location. The foam baffle is a critical part
for proper cooling of the BPEs.
illustration on page 117). Remove the cross brace.
rail (item 3 in illustration on page 117).
rail (item 3 in illustration on page 117).
4
2
1 Rack Top Frame
2 Rack Chassis
3
Top Frame Bolts
4
Rack Top Frame Cross Brace

Advertisement

Table of Contents
loading

Table of Contents