IBM eserver pSeries 690 Installation Manual page 34

|
connection is made.
|
|
|
This figure illustrates the back of the machine UEPO panel with the room EPO cable
|
plugging into the machine. Notice the switch actuator. Once the switch actuator is
|
moved to make the cable connection possible, the room EPO cable must be installed
|
for the machine to power on.
|
|
|
In this figure, an AMP connector 770019-1 is needed to connect to the system UEPO
|
panel. For room EPO cables using wire sizes #20 AWG to #24 AWG, use AMP pins
| part number 770010-4.
18
pSeries 690 Installation Guide
4 AMP Part Number - 770019-1
3 1
2
Contact Number
2 Pole Normally Closed Pushbutton