IBM eserver pSeries 690 Installation Manual page 72

1. Be sure the rack is in the correct location.
6
5
4
3
2
2. Place the mounting plates (item 1 in illustration on page 56), front and rear, in the
approximate mounting position under the system rack.
3. To align the mounting plates to the system rack, do the following:
a. Place the four rack-mounting bolts (item 6 in illustration on page 56) through
b. Position the mounting plates (item 1 in illustration on page 56) under the four
c. Turn the rack-mounting bolts (item 6 in illustration on page 56) three or four
56
pSeries 690 Installation Guide
the plate assembly holes at the bottom of the rack. Install the bushings and
washers (item 4 and 5 in illustration on page 56) to ensure bolt positioning.
rack-mounting bolts (item 6 in illustration on page 56) so that the mounting
bolts are centered directly over the tapped holes.
rotations into the tapped holes.
1
Rack Tie Down (Non-Raised Floor)
6
5
4
3
2
1