Konica Minolta bizhub36 Users Manual Network Administration page 60

4
Settings
[Feed Zoom]
[Paper Separation Adjust-
ment]
[Gradation Adjustment]
[Max Image Density Adj]
[Replenish Toner]
Factory default
[Paper Separation Adjust-
ment]
[Max Image Density Adj]
4-28
[Plain Paper] Adjust the feed direction zoom ratio of paper
types.
[Thick 1]
[Thick 2]
[Envelope]
[First Side] Adjust the paper position where the two sides are
separated for 2-sided print.
[Second Side]
Adjust irregular gradation levels of print images.
[Max. Density Adjust- This function is useful when the required printing
ment] result is not obtained, for example, the printing
density is too high or too low. Scan the amount of
toner adhered on an output test pattern, and ad-
just to the optimal density.
For details, refer to page 4-31.
[Gradation Adjust- This function is useful when a print image is not
ment] reproduced with consistent density. Scan the
density of an output test pattern and adjust to the
optimal gradation.
For details, refer to page 4-32.
This function is useful when the required printing result is not obtained, for
example, the printing density is too high or too low. Adjust the amount of
toner that is to be adhered to the paper based on the printing density value
set to the highest level in order to fine-adjust the entire printing density set-
ting (amount of toner).
If the required printing density result is not obtained after the maximum im-
age density has been adjusted, contact your service representative.
Directly after replacing the toner bottle or after printing a large number of
originals with many black areas, the machine cannot sufficiently replenish
the toner, and printing density may fall temporarily. In this case, using this
function forcibly replenishes the toner.
Press Start to start replenishing toner.
[0.0mm]
[0]
[Maintenance Menu]
bizhub 42/36
4.10