Configuring Traffic Redirect Settings; Figure 45 Network > Wan > Traffic Redirect; Table 19 Network > Wan > Traffic Redirect - ZyXEL Communications MAX-200M1 Series User Manual

ZyXEL MAX-200M1 Series User's Guide
Table 18 Network > WAN > Advanced
LABEL
Allow between LAN
and WAN
Allow Trigger Dial
Apply
Reset

7.6 Configuring Traffic Redirect Settings

To change your ZyXEL Device's traffic redirect settings, click Network > WAN > Traffic
Redirect. The screen appears as shown.
Figure 45 Network > WAN > Traffic Redirect
The following table describes the labels in this screen.
Table 19 Network > WAN > Traffic Redirect
LABEL
Traffic Redirect
Active
Backup Gateway
IP Address
80
DESCRIPTION
Select this check box to forward NetBIOS packets from the LAN to the WAN
and from the WAN to the LAN. If your firewall is enabled with the default policy
set to block WAN to LAN traffic, you also need to enable the default WAN to
LAN firewall rule that forwards NetBIOS traffic.
Clear this check box to block all NetBIOS packets going from the LAN to the
WAN and from the WAN to the LAN.
Select this option to allow NetBIOS packets to initiate calls.
Click this button to save your settings.
Click this button to return all the fields in this screen to their default values.
DESCRIPTION
Select this check box to have the ZyXEL Device use traffic redirect if the normal
WAN connection goes down.
Note: If you activate traffic redirect, you must configure the Check
WAN IP Address field.
Type the IP address of your backup gateway in dotted decimal notation. The
ZyXEL Device automatically forwards traffic to this IP address if the ZyXEL
Device's Internet connection terminates.
Chapter 7 WAN Setup