On-Screen Timer Programming - JVC HR-S7300U Instructions Manual

42
On-Screen
Timer
Programming
+
–
1 2
4 5
DIGIT
7 8
0
3
6
MENU
9
SET
TIMER RECORDING (cont.)
You can directly program the VCR's timer to record up to 8
shows, as far as a year in advance. Remember, the clock must
be set before you can program the timer (
LOAD A CASSETTE
1
Make sure the record safety tab is intact. If not, cover
the hole with adhesive tape, then load.
The VCR comes on, and the counter is reset,
automatically.
ACCESS ON-SCREEN
MENU
2
Press MENU as many times as necessary to bring up the
Main Menu screen.
ACCESS PROGRAM SET
SCREEN
3
Make sure the arrow is to
the left of "PROGRAM
SET", then press SELECT.
SELECT PROGRAM
NUMBER
4
Press SET +/– to select a vacant program number, then
press SELECT. The first time you do this, all numbers will
be vacant, so just press SELECT when the screen appears.
SET PROGRAM
INFORMATION
5
Press SET +/– to set the month, then press SELECT. The
day display begins blinking. Repeat the procedure to set
the day, start time, stop time, channel and tape speed.
To set the channel you can also use the DIGIT keys.
Do not use the SET – button to set the date.
If the line input is to be used as a source for a Timer
Record event please select "AUX" as input channel
and set Cable Box output to "OFF" (
Box timer recording and control by the VCR is no
longer possible.
** You can record selected programs at the same time
every weekday, or once a week. Before entering the
month or day, press DIGIT key "8" (DAILY) or "9"
(WEEKLY). Either "DAILY" or "WEEKLY" appears.
Press again and "DAILY" or "WEEKLY" disappears.
For weekly recording, the desired date for the day of
the week must be entered.
pg. 8 or 9).
PROGRAM 1
DATE - - / - -
START - - : - - AM
STOP - - : - - AM
CHANNEL - - SP
PRESS (SELECT, SET+/–)
PRESS (MENU) TO END
pg. 17). Cable