Cable Box Control; Situate And Connect Controller - JVC HR-S7300U Instructions Manual

16
Cable Box
Control
Suggested Location
Place the cable box on top of the VCR. Attach the VCR's Cable
Box Controller to the top of the VCR with the Controller's
transmitter pointed towards the cable box's remote sensor.
Your VCR
Cable box
Controller
Your VCR
Cable box
Controller
(suggested locations)
Transmitter
Connected
Connected to
to VIDEO/
ANT. IN
AUDIO IN
CABLE
BOX
INITIAL SETTINGS (cont.)
This procedure is required if you receive your TV channels
through a cable box (descrambler). The Cable Box Controller
allows the VCR to automatically switch the cable box channel
during timer-recording. The Cable Box Controller is effective for
recording shows that have been programmed using VCR Plus+
( pg. 40) or On-Screen Timer Programming (
Situate And Connect
Controller
SITUATE CONTROLLER
1
Place the Cable Box Controller so that the path
between its transmitter and the cable box's remote
sensor is unobstructed.
ATTACH CONTROLLER
2
Fasten securely using the supplied adhesive strips.
CONNECT CABLE BOX TO
VCR
3
The connection method depends on the type of cable
box you have.
If your cable box has AUDIO and VIDEO OUT
connectors . . .
. . . connect them to the AUDIO and VIDEO IN
connectors on your VCR. Set the VCR to channel "AU"
to use the cable box.
If your cable box doesn't have AUDIO and VIDEO
OUT connectors . . .
. . . connect the antenna output connector on the cable
box to the ANT.IN connector on the rear of your VCR.
Set the VCR tuner to the same channel as the cable box
RF output (see page 18 also).
NOTE:
Refer to your cable box's instruction manual during
connection.
CONNECT CONTROLLER
TO VCR
4
Connect to the CABLE BOX connector on your VCR.
About Your Cable Box
This VCR has two separate methods to control your Cable Box.
The VCR's Wireless Remote Control Unit can control your
Cable Box.
This eliminates the need for a separate Cable Box Remote
Control Unit.
The VCR's Cable Box Controller can also control your Cable Box.
This allows the VCR to change your Cable Box's channel
number during timer recording.
Each method must be set up separately. To set up the VCR's
Remote Control unit, refer to page 56. To set up the Cable Box
Controller go to page 17.
pg. 42).