Display Tape Remaining Time - JVC HR-S7300U Instructions Manual

38
+
–
1 2
4 5
7 8
0
OSD
DISPLAY
PLAYBACK AND RECORDING FEATURES (cont.)
3
6
MENU
9
RETURN TO NORMAL
SCREEN
7
Press MENU as many times as necessary to exit.
NOTE:
Noise will increase if the recording level is too low, while
distortion will increase if the level is too high.
Display Tape Remaining
Time
DISPLAY COUNTER
INFORMATION
1
Press OSD.
DISPLAY TAPE REMAINING
TIME
2
Press DISPLAY until "REMAIN" appears on screen. The
approximate tape remaining time appears on the TV
screen and VCR display panel.
• The tape remaining time is calculated based on the
tape speed (SP or EP) being used. The indicated
remaining time is only an estimate.
• By pressing DISPLAY, you can change the indication
on the display panel to show the counter reading,
channel number, clock time or tape remaining time.
EXIT THE DISPLAY
3
Press OSD again.
NOTES:
"SUPERIMPOSE" must be set to "ON", or the on-screen
display will not appear ( pg. 30).
Near the beginning of the tape, this estimate may be inaccu-
rate. However, as the tape is used and the amount of
remaining tape decreases, the estimate becomes more
accurate.
The tape remaining time indication is not accurate when
using VHS-C tapes with VHS-C adapter.