Table of Contents
Advertisement
ASSEMBLING STA N D A N D
D U S T C H U T E TO JOINTER
M A K E C E R TAIN T H E MACHINE I S DISCONNECTED
F R O M T H E P O W E R S O U R C E A N D T H AT KNIFE
G U A R D ( A ) FIG. 1 3 , I S POSITIONED O V E R T H E C U T-
TERHEAD.
1 . C ar efu lly turn the jointer (A) Fig. 7, upside-down so
t h e table is resting on a supporting surface similar to the
two pieces of 4
x 4
lumber as shown. T h i s w i l l f a c i l i-
t ate the assembly of the dust chute (B) F i g . 8 , a n d s tand
( C ) t o t h e j o i n t e r.
2 . Align the three mounting holes (D) F i g . 8 , i n t h e s tand
with three mounting holes in the base of the jointer as
shown in Fig. 8.
3 . Position dust chute (B) Fig. 9, as shown, over two of
the holes (D) that were aligned in STEP 2.
4 . Assemble the dust chute (B) and stand (C) F i g . 9 , a t
each hole (D) with a 5/16-18 x 1-1/4
screw (E), two flat washers (F), and hex nut (G). NOTE:
Screws are to be installed upward from the base of the
j o i n t e r.
5 . C a r e f u l l y t u r n t h e j o i n t e r w i t h s tand and dust chute
a t tached so the jointer is resting on the stand. IMPOR-
TA N T:W e strongly suggest that two people perform this
operation.
6 . Apply downward pressure on the jointer so the legs
o f t h e s tand are adjusted to the floor surface and tighten
a l l s tand mounting hardware.
D
D
ASSEMBLING B ELT
AND PULLEY G U A R D
M A K E C E R TAIN T H E MACHINE I S DISCONNECTED
F R O M T H E P O W E R S O U R C E A N D T H AT KNIFE
G U A R D ( A ) FIG. 1 3 , I S POSITIONED O V E R T H E C U T-
T E R H E A D.
1 . Loosely thread two 1-1/4-20 x 1/2
screws (A) F i g . 1 0 , i n t o t h e t w o tapped holes at the rear
o f t h e j o i n t e r ta b l e .
2 . I n s e r t s l o ts in guard (B) under heads of screws (A)
as shown in F i g . 11, and tighten screws to hold guard in
p o s i t i o n .
long hex head
C
D
G
F
E
F i g . 9
truss head
D
8
A
F i g . 7
B
D
D
F i g . 8
Fig. 10
A
F i g . 11
C
A
B
A
B
Hide quick links:
Advertisement
Table of Contents
