I t i s i m p o r tant that the machine be set on a solid, level foundation. If rocking occurs,
place metal shims at the corners between the base and the floor. Lag screws or bolts
may be used if desired to secure the machine to the floor using the same holes that
fastened the machine to the shipping skid.
ASSEMBLING DUST HOOD
1 . Assemble the dust hood (A) F i g . 8 , t o t h e o u tfeed
end of the jointer base using the seven 5/8 long button
head screws (B) as shown.
MOVING STA R T-STO P
SWITCH TO THE UP POSITION
1 . For shipping purposes, the start-stop switch and
switch arm (A) is shipped in the down position, as shown
in Fig. 9. Simply remove the two screws (B) Fig. 9, rota t e
switch and switch arm (A) 180 degrees, as shown in
Fig. 10, and replace the two screws (B).
ASSEMBLING
JOINTER FENCE
1 . Assemble the jointer fence assembly (A) F i g . 11 , t o
the machine cabinet, as shown, using the two 1-1/8
long screws (B) and flat washers supplied.
SELECTING FLOOR SPA C E
A S S E M B LY INSTRUCTIONS
B
A
F i g . 9
B
A
B
A
B
8
B
F i g . 8
A
B
Fig. 10
B
F i g . 11