Stand And Electricals; Assembling Jointer To Stand Or Bench - Delta DJ-15 Instruction Manual

Hide thumbs Also See for DJ-15:

Table of Contents

STAND AND ELECTRICALS

If you purchased your jointer complete with stand and

electricals, factory mounted and wired, the stand is shipped

with the motor and switch completely wired and assembled

to the stand, as shown in Fig. 2.

ASSEMBLING JOINTER

TO STAND OR BENCH

If the jointer is to be used with the stand shown in Fig. 2. the

outfeed end of the jointer is to be at the same end of the

stand as the chip chute (A) Fig. 2. Line up the four holes (B)

Fig. 3, on the top of the stand with the four threaded holes

on the bottom of the jointer base and fasten the jointor to the

stand using the four

" long socket head cap screws and

lockwashers supplied.

If the jointer is to be used without the stand shown in Fig. 2.

we recommend that the jointer be fastened to a supporting

surface using the four threaded holes in Ihe jointer base.

Fig 4 illustrates the size and center to center distance

of the holes fo be drilled in the supporting surface.

IMPORTANT: Carp must hp taken that an opening is pro¬

vided in the supporting surface to facilitate the removal of

wood chips. The location and si/e of this opening is shown

in Fig. 4 NOTE: If the motor is going to be located below the

jointer an opening must also be provided for Ihe belt.

Fig. 2

Table of Contents