Table of Contents
Advertisement
Before you install
Selecting the site
After meeting general requirements, the site for the Select printer should meet the
electrical, physical, and environmental requirements of the printer.
Environmental requirements
The Select printer requires the following environmental conditions for optimal
operation:
•
•
i
The maximum operating temperature might be different from the recommended
If you store the Select printer, provide an environment with the following conditions:
•
•
Remove all supplies from the printer before storing.
Electrical requirements
The Select printer requires the following electrical conditions for optimal performance:
•
•
The rated input current for the Select printer is 1.4 amps at 100 VAC applied.
Physical requirements
The Select printer requires an environment that accommodates its physical
dimensions and weight.
The printer weighs between 21 and 26.5 pounds or 9.7 and 11.9 kilograms.
i
The dimensions are:
•
•
•
•
Do not block the back air vents or fan opening on the Select printer.
User's Guide for Select™ Platinum Series™ Printers
Operating relative humidity: 20% to 80% non-condensing
Operating temperature range: 55° F to 95° F (13° C to 35° C)
storage temperature.
Storage relative humidity: 20% to 80% non-condensing
Storage temperature range: 0° F to 100° F (-17.8° C to 37.8° C)
100-230 VAC (+/- 10%) at 50/60 Hz (The Select printer automatically adjusts to
any power within this range.)
Single phase, 3-wire grounded receptacle only
The surface holding the printer might also need to bear the weight of other
equipment such as a PC and camera.
Depth of 17.8 inches (54.1 cm) for Select models without duplex or smart card
modules
Depth of 24 inches (65 cm) for Select models with duplex or smart card modules
Width of 8.8 inches (22.2 cm)
Height of 10 inches (25.4 cm)
6-3
Advertisement
Table of Contents
