Powering On The Printer And Pc - DataCard select series User Manual

Using the printer
6
Replace the print ribbon cartridge
1
2
3

Powering on the printer and PC

Use the following procedure to power on the printer and attached PC.
Power on the printer and PC
i
1
2
3
4
User's Guide for Select™ Platinum Series™ Printers
Make sure print ribbon unwinds over the top of the print ribbon cartridge, not from
the bottom.
Place the ribbon cartridge onto the ribbon cartridge supports (see Figure 2-9).
Make sure the cartridge is securely seated. Avoid touching the printhead cartridge
and ribbon tracker.
Figure 2-9: Replace the print ribbon cartridge
Close the swing arm, pressing it down until the push latch clicks into place.
Close the cover.
If the printer is connected over a network using a print server, make sure the
driver is installed and configured on the PC before using it.
Make sure cards and all other supplies are loaded. See other sections of this
chapter for more information.
Remove any printed or rejected cards from the output stacker. See "Removing
cards" on page 2-12 for more information.
Make sure the power cord and data cable are connected. If needed, see
"Connecting cables" on page 7-3 for more information.
Press the printer Power switch to turn on power. Observe the printer status light
which lights with a sequence of colors and then becomes steady green. See
"Status light" on page 2-9 for more information. The printer initializes components
and makes audible sounds.
♦
♦
2-7