Step 1 Mount Template; Step 2 Adjust Frame Height - Monogram ZV925 Installation Instructions Manual

STEP 1 MOUNT TEMPLATE

• Align the template with the marks on the ceiling
and tape in place.
– Be sure the template is oriented correctly
with the front of the hood.
• Use a plumb bob to be sure the mounting holes
will provide parallel alignment with the countertop
below.
• Center punch all hole locations.
• Drill pilot holes in the 4 screw locations. Use a 3/16"
bit and drill approximately 1-1/2" deep.
• Drive 4 hex head wood screws into the center of
the ceiling joists and cross framing. Leave a 1/4"
gap to allow the screw head to engage the keyhole
slots on the support frames.

STEP 2 ADJUST FRAME HEIGHT

•Measure exact ceiling height.
• Find the exact frame height
required on the chart on page 6.
• Place the support on a work
surface. Remove 2 screws on
each of the 4 sides of the frame
to loosen the upper structure,
lower structure and blower/
motor.
• Adjust the height "X", according
to the chart on page 6.
• Use a marker pen to indicate
where screw holes should align
in the assembled upper, lower
and blower/motor pieces.
Installation Instructions
Frame
height
2-3/4"
NOTE: Low ceilings may require that
the lower portion of the support frame be
removed. The upper support frame may be
secured directly to the blower/motor. Refer
to the chart on page 6 for your ceiling
height and to be sure the duct cover trim
piece will fit.
18
Drill 3/16≤
Pilot Holes
Approx. 1-1/2≤
Deep
10-1/16≤ to
Centerline
of Holes
7-1/16≤ to
Centerline
of Holes
36≤ Hood
Template
Cut a 1≤ Dia.
Wire Access
Hole
FRONT OF HOOD
1/4" Gap
Mark
24" min.
Ceiling
each
height
30" max.
piece to
indicate
where
screw
holes
align.
36" min.
Cut a 1≤ Dia.
Wire Access
Hole
Drill 3/16≤
Pilot Holes
Approx. 1-1/2≤
Deep
7-1/16≤ to
Centerline
of Holes
NOTE: Do not cut the
duct opening shown
on the template for
this recirculating
installation.
X