Step 2A, Install Hood Onto Well - Monogram ZV48T Installation Instructions Manual

Installation Instructions
ISTEP 2A I INSTALL HOOD ONTO WALL
SKIPTHIS STEPIF INSTALLING BENEATHA SOFFITOR CABINET,
GO TO STEP2B.
Locate at least 2 vertical studsat the wood support.
Centerthe suppliedwood support, left to right and belowthe
15-3/8" marked line.
LLL......
',[ ..... \\\, ,----_ _
: -.--i!.2[.-
: 30"
1 to
I 36"
I ;'_r-- _
i] ......
" II
IP ........ W ood
i' II
Support
II
:I
il
,u
ii
,i
ii
Centerli_-_-"
Installation 1
Space
I
Securethe wood support to 2 or more vertical studs,using at
least 2 of the/4 suppliedlong screws.
IMPORTANT: Screwsmust penetrate at least 1-1/2" into verti-
cal studs. Countersinkscrewsinto support.
Note: The mounting
screws must remain in
their original shipping
location. These screws
are positioned to en-
gage the keghole slots
the back of the hood.
i
i
i
i
i
]
- i
q
]'
OriginalMounting
Screwsas Shipped
LM'
Adjust depth of original mounting screwsin the wood support
until theg protrude 1//4'forward. This 1//4"gap will provide
clearanceto hang the hood.
IMPORTANT: Framing must be capable of
supporting up to 150 Ibs.
Install Transition Onto Top of Hood
IMPORTANT:Remove
shipping tape from
damper and check that
damper moves freelg.
Duct
Transition
• Placethe transition piece overthe hood exhaust and secure with
/4screws provided.
• Useduct tape to sealthe connection. Checkto be surethe
damper movesfreely.
Hang Hood On Wood Support
• Lift the hood and hold closeto the installation location.Route
housewiring through the knockout and into thejunction box.
• Placethe hood overthe wood support. Be surethe mounting
screwsengage the kegholeslotsin the back of the hood.Tighten
the screws.
AWA RNING: Continue to provide additional
support while the hood is mounted with only these 2 screws.These
screwswill not support the weight of the hood.The hood could fall
resulting in damage or personalinjurg.
A AVE RTISSE M ENT-Con in e fo mi n
additionnel p endantle montage de la hotteavecces deuxvis seulement. C es
deuxvisne soutiendront pas lepoidsdela hotte.La hottepeuttomber,occasi-
onnantdesblessurescorporelles o u des dommages m atdriels.
• Checkto be surethe hood is leveland centered.
36"
"_ /Space
Test Duct Cover Fit
• Placeduct cover(s)overthe top of the hood to checkfor gaps.
Adjust the hood up or down if necessarg.
Install Bottom Mounting Screws
Drill 1/8" pilot holesinto the two lower mounting holes.Enlarge
the holesif theg did not enter studsto 3/8".insert anchors
for wall fasteners into bottom holes.Removeanchor screws
and add flat washersprovided.Drive screwsinto anchors and
tighten.
install/4 additional screwsthrough the back of the hood and
into the wood support.
2 49 80151 8