Step 11 Install Lower Duct Cover; Step 12 Install Duct Cover Trim; Step 13 Install Metal Filter; Step 14 Finalize Installation - Monogram ZV925 Installation Instructions Manual

STEP 11 INSTALL LOWER DUCT COVER

Front bottom duct cover section
(snap into place and secure
with 6 screws – 3 per side)
Plan diagram
top view
• Place rear duct cover onto the hood.
• Place front duct cover onto the hood.
• Secure the duct covers with 6 screws.
Installation Instructions
Front bottom duct
cover sections
17

STEP 12 INSTALL DUCT COVER TRIM

Upper
Side
trim
bracket
strip
Lower
trim strip
• Install side brackets to secure the lower duct
tightly against the upper duct.
• Hold lower trim strips (narrow pieces) with hooks
facing down. Place the hooks inside the slots and
slide downward.
• Select the correct size upper trim strips and press
into place.

STEP 13 INSTALL METAL FILTER

IMPORTANT: Check to be sure that the main ON/
OFF switch next to the motor is in the ON
position.
Filter lock
• Tip the filter into the left or right side of the
opening. Lift the filter to the opposite side and
into the filter lock.
• To remove the filter, pull the filter lock downward.

STEP 14 FINALIZE INSTALLATION

• Remove all tape and packing material.
• Refer to the Owner's Manual for operating instructions.
Upper
trim
strip
Lower
trim
strip