Forward-Facing Installation; Vehicle Belt - DJG Alpha Omega Instruction Manual

Forward-Facing Installation

After deciding whether to use your Vehicle Belts or
LATCH, be sure to read the warning below as they
pertain to both systems.
When LATCH is not being
used, fasten belt hooks
together behind the child
restraint as shown.
WARNING
!
A loose LATCH system can result in serious
injury or death.
34
4358-5843A US All in One.indd 37-38 4358-5843A US All in One.indd 37-38
Forward-Facing Installation with
Vehicle Belts:
Place child restraint flush
1
against the back of the
vehicle seat forward-
facing in the back seat.
The recline position
is to be used only to
install the child restraint
flush against the back of
the vehicle seat back, if
needed.
Thread the vehicle lap
belt or lap/shoulder belt
combination through the
belt path and out other
side. Buckle.
Place one knee in the
2
child restraint and
push down firmly while
pulling up on belt to
tighten. For a manual
belt, refer to "Knowing
Your Vehicle Belt"
section.
With knee still in child
3
restraint, attach hook to
anchor in vehicle. Push
down firmly and tighten
top anchorage strap.
To adjust top anchorage
strap: See "Adjusting Top Anchorage Strap" section.
NOTE: If your vehicle does not have an anchor
bracket, attach the tether hook to the bottom of the
base.
35
continued on next page.
1/26/12 11:06 AM 1/26/12 11:06 AM