Table of Contents
Advertisement
4358-4582 Alpha Omega 50lb
8/15/08
Forward-Facing Installation
After deciding whether to use your Vehicle Belts or
LATCH, be sure to read the warnings below as they
pertain to both systems.
WARNING:
!
A loose LATCH system can result in
serious injury or death.
34
9:48 AM
Page 37
You may need to remove
the base for narrow vehicle
seats or airline use. See
"Removing Base" in Belt-
Positioning Booster
section.
NOTE:
To install the child
restraint without the base,
use either the recline
mode or upright mode.
For upright mode, rotate
recline stand down and
out, then push up to lock.
When LATCH is not being
used, fasten belt hooks
together behind the child
restraint as shown.
Forward-Facing Installation with
Vehicle Belts:
Place child restraint flush
1
against the back of the
vehicle seat forward-
facing in the back seat.
The recline position is to
be used only to install the
child restraint flush against
the back of the vehicle
seat back, if needed.
Thread the vehicle lap
belt or lap/shoulder belt
combination through the
belt path and out other
side. Buckle.
Place one knee in the
2
child restraint and push
down firmly while pulling
up on belt to tighten. For
a manual belt, refer to
"Knowing Your Vehicle
Belt" section.
With knee still in child
3
restraint, attach hook to
anchor in vehicle. Push
down firmly and tighten
top anchorage strap.
To adjust top anchorage strap: See "Adjusting Top
Anchorage Strap" section.
NOTE:
If your vehicle does not have an anchor
bracket, tuck the top anchorage strap's hook under
the child restraint.
35
continued on next page.
Advertisement
Table of Contents
