Installation/Connection/Setup Of Speakers (Advanced); Speaker Installation - Marantz NR1604 Owner's Manual

Installation/connection/setup of speakers (Advanced)

Procedure for speaker settings

Speaker installation

Speaker connection (vpage 81)
Set up speakers (vpage 91)
DVD
Speaker installation
• Determine the speaker system depending on the number of speakers
you are using and install each speaker and subwoofer in the room.
Here, we explain how to install the speakers using a typical example.
• The speaker impedance should be from 6 to 16 Ω/ohms.
This unit is compatible with Dolby Pro Logic gz (vpage 150)
and DTS Neo:6 (vpage 151) which offers an even wider and
deeper surround sensation.
When using Dolby Pro Logic gz, install front height speakers.
Use the illustration below as a guide for how high each speaker should
be installed. The height does not need to be exactly the same.
Surround
Front height
speaker
speaker
• Point slightly
downwards
At least
2 – 3 ft /
3.3 ft / 1 m
z
60 – 90 cm
Front
speaker
GViewed from the sideH
z Recommended for Dolby Pro Logic gz
79
When 7.1-channel speakers are installed
using surround back speakers
FL
z2
SL
Surround back
speaker
• Point slightly
z1 22˚ – 30˚
downwards
NOTE
You cannot have audio output from the surround back speakers and
front height speakers simultaneously.
GSpeaker abbreviationsH
FL Front speaker (L)
FR Front speaker (R)
C Center speaker
SW Subwoofer
FR
SW
C
z1
z3
SR
Listening
position
SBL SBR
z2 90˚ – 110˚ z3 135˚ – 150˚
SL Surround speaker (L)
SR Surround speaker (R)
SBL Surround back speaker (L)
SBR Surround back speaker (R)
v See overleaf