Zone Rename; Zone2 Setup - Marantz NR1604 Owner's Manual

Language
Set the language for display on the menu screen.
English / Français / Español
"Language" can also be set by the following procedure. However, the menu screen is not displayed.
Following the display content to make the setting.
ZONE2 SOURCE
1. Press and hold the main unit's
"V.Format:<NTSC>" appears on the display.
2. Press the main unit's DISPLAY
and set "Lang.:<ENGLISH >".
3. Use the main unit's ZONE2 SOURCE INTERNET RADIO
or
STATUS
4. Press the main unit's to complete the setting.

ZONE2 Setup

Set the audio to play back with multi-zone (ZONE2).
Setting items
Lch Level –12dB – +12dB (0dB)
Adjust the left channel
output level.
Rch Level –12dB – +12dB (0dB)
Adjust the right channel
output level.
Volume Level Variable : Volume adjustment is enabled by main unit and remote control
Set the volume output level. unit.
1 – 98 (–79dB – 18dB) : The volume is adjusted to the set level.
Volume Limit 60 (–20dB) / 70 (–10dB) / 80 (0dB)
Make a setting for Off : Do not set a maximum volume.
maximum volume.
This is displayed from –79 dB to 18 dB when "Scale" (vpage 112)
is set to "–79.5dB – 18.0dB".
DVD
Default settings are underlined.
Setting details
STATUS
and for at least 3 seconds.
and set the language.
Default settings are underlined.
Setting details
Setting items
Power On Volume Last : Use the memorized setting from the last session.
Mute : Always mute when power is turned on.
Define the volume setting
that is active when the 1 – 98 (–79dB – 18dB) : The volume is adjusted to the set level.
power is turned on.
This is displayed from –79 dB to 18 dB when "Scale" (vpage 112)
is set to "–79.5dB – 18.0dB".
Mute Level Full : The sound is muted entirely.
Set the amount of –40dB : The sound is attenuated by 40 dB down.
attenuation when muting –20dB : The sound is attenuated by 20 dB down.
is on.

Zone Rename

Change the display title of each zone to one you prefer.
MAIN ZONE / ZONE2
• Up to 10 characters can be input.
• For character input, see page 107.
Set Defaults : The input source name is returned to the default setting.
• Reset : Reset to the defaults.
• Cancel : Do not reset to the defaults.
If you select "Set Defaults" and press
names to the factory defaults?" is displayed. Select "Reset" or "Cancel",
ENTER
and then press .
132
Setting details
Setting details
ENTER
, the message "Reset all zone
General