Marantz NR1604 Owner's Manual page 29

Check
13
ui
Use to select the item you
want to check, and then press
ENTER
.
Audyssey Setup
Check processing results. To proceed, press "Store".
Speaker Config.
Distances
Levels
Crossovers
Store
• Subwoofers may measure a greater reported distance than
the actual distance due to added electrical delay common in
subwoofers.
BACK
• If you want to check another item, press
NOTE
• If the result differs from the actual connection status, or if "Caution!"
is displayed, see "Error messages" (vpage
Audyssey ® Setup again.
• If you change speaker positions or orientation, perform Audyssey ®
Setup again to find the optimal equalizer settings.
DVD
Store
14
Select "Store" and then press
Save the measurement results.
Check processing results. To proceed, press "Store".
Speaker Config.
Distances
Crossovers
Now storing...Please wait.
.
27). Then carry out
• Saving the results requires about 20 seconds.
• During saving of measurements results, "Now storing...Please
wait." is displayed. When saving is completed, "Storing complete.
Audyssey ® Setup is now finished. Please unplug microphone." is
displayed.
NOTE
During saving of measurement results, be sure not to turn off the
power.
ENTER
.
Audyssey Setup
Levels
Store
Audyssey Setup
50%
26
Set up speakers (Audyssey® Setup)
Finish
15
Unplug the Setup and measurement microphone
from the unit's SETUP MIC jack.
16
Set Audyssey Dynamic Volume ® .
Audyssey Setup
You can set Dynamic Volume function, which automatically
adjust volume level for all content.
Do you want to enable?
Yes
No
• This feature adjusts the output volume to the optimal level while
constantly monitoring the level of the audio input to the unit.
Optimal volume control is performed automatically without any
loss in the dynamism and clarity of the sound when, for example,
the volume suddenly increases for commercials shown during
television programs.
n When turning Dynamic Volume on
• Press u to select "Yes", and then press
The unit automatically enters "Medium" (vpage 113) mode.
n When turning Dynamic Volume off
i ENTER
• Press to select "No", and then press
NOTE
After performing Audyssey ® Setup, do not change the speaker
connections or subwoofer volume. In event of a change, perform
Audyssey ® Setup again.
ENTER .
.