Set Up Speakers - Marantz NR1604 Owner's Manual

Set up speakers

This section describes detailed settings for Audyssey ® Setup.
First install and connect the speakers to this unit.
Before Audyssey ® Setup measurement, the settings shown below can be made.
• Changing the amplifier assignment (Amp Assign)
The signal output from the SURROUND BACK speaker terminals of this unit can be switched to match your speaker environment
• Setting the channels to be used (Channel Select)
If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers
"Set up "Channel Select"").
1
Set up the zone mode
MAIN
Press to switch the zone mode.
MAIN lights.
Press MAIN
DVD
2
Connect the Setup and
measurement microphone.
When the Setup and
measurement microphone is
connected, the following screen is
displayed.
Audyssey Setup
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
Amp Assign
Channel Select
Check Results
Restore...
Start
91
around items indicate the settings.
(vpage 91 "Set up "Amp Assign"").
3
Set up "Amp Assign"
ui
Use to select "Amp Assign", and then press
ENTER
.
Audyssey Setup
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
Amp Assign
Channel Select
Check Results
Restore...
Start
Amp Assign
Assign Mode
Front Speaker
Center Speaker
Surround Speaker
Surr. Back Speaker
ZONE2 Not Used
Selects how to use the internal amplifiers
4
Select "Assign Mode", and then press
(vpage 92
[1/2]
Surround Back
ZONE2:
ENTER
.
v See overleaf