Marantz NR1604 Owner's Manual page 113

Setting items
Low Frequency Effects –10dB – 0dB
Adjust the low-frequency
For proper playback of the different sources, we recommend setting
effects level (LFE).
to the values below.
• Dolby Digital sources : 0dB
• DTS movie sources : 0dB
• DTS music sources : –10dB
Center Image 0.0 – 1.0 (0.3)
Distributes the dialogue
The smaller the value, the more dialogue is concentrated on the center
output from the center
channel. The larger the value, the more dialogue is distributed to front
channel to the front left and
left and right channels, and the more the sound image widens in the
right channels and widens
front.
the sound image in the
front. You can set this when
the sound mode is set to
DTS NEO:6.
Panorama On : Set.
Off : Do not set.
Assign front L/R signals
to also go to the surround
channels for wider sound.
You can set this when the
sound mode is Dolby PLg in
the "Music" mode.
Dimension 0 – 6 (3)
Shift sound image center
As you set a smaller number, the surround sound field shifts backward;
to front or rear to adjust
as you set a larger number, the surround sound field shifts forward.
playback balance. You can
set this when the sound
mode is Dolby PLg in the
"Music" mode.
Center Width 0 – 7 (3)
Distributes the dialogue
The smaller the value, the more dialogue is concentrated on the center
output from the center
channel. The larger the value, the more dialogue is distributed to front
channel to left and right
left and right channels, and the more the sound image widens in the
channels and widens the
front.
sound image in the front.
You can set this when the
sound mode is Dolby PLgx
in the "Music" mode.
DVD
Setting details
110
Setting items
Height Gain Low : Reduce the front height channel volume.
Normal : Front height channel sound is output with standard sound
Control the front height
channel volume. volume.
High : Increase the front height channel volume.
NOTE
"Height Gain" is displayed for the following settings.
• When "Assign Mode" (vpage 124) is set to "Front Height".
• When the "Speaker Config." – "Front Height" setting (vpage 124) is
set other than to "None".
• When sound mode is "PLgz" or the PLgz decoder is used.
Set Defaults Reset : Reset to the defaults.
The "Surround Parameter" Cancel : Do not reset to the defaults.
settings are returned to the
When you select "Set Defaults" and press
default settings.
ENTER
, the "Reset all surround parameters
to the factory defaults?" prompt is displayed.
Select either "Reset" or "Cancel", and press
ENTER
.
Audio
Setting details