Advertisement
. *Attach the antenna to the inner glass s&ace of the rear wlndow ustng double--sided tape. Carefully check ihe installal~on
locatlon as the tape can only be stuck on once.
* If the surface temperature of the glass of the rear window is low, v\varrn It by turning on the power of the rear defogger.
A cold window glass surface will weaken the adhesive strength oi'the double--sided tape.
Also, if installation Inside Ihe cabin IS performed on a day w&h high humid+ or when It is ralrlng. Ihe high lh~umid~ty level will
weaken the adhesive strength of the double-sided tape.
@ Do not Install the antenna in a location where it may obstr-uct the fleld of view during driving, sluch as on the wlndshielci.
Check the location where the antenna IS to be attached.Clean
off any grease or dirt from the Installation locatlon using the
supplled glass cleaner !Accessory la:), clean the area with water
alncl allow to dry.
~~~
Clean the glass thoroughly as fatlure to clean Ihe glass can not
only weaken the adhesive s'trenglh of the double-sided tape,
but may also cause it to come loose.
Remove the protective SNIPS from the antenna parts and ihe
back of the antenna unit.
3 Attach the double-sided tape of ihe antenna parts and the
antenna unit to the rear wrndshield glass. Attach the cloubiu-
sided tape by firmly pressing clown from the top. Sccure cables
using the supplied clarnpers.
After attachlny the antenna with Ihe double-sldecl tape, allow II
to sit undisturbed for 24 hours. Take care not to apply force to
the antenna or allow It to get wet during this lime.
Connect the antenna cable to fecelver unit.
Advertisement
