Advertisement
1. To prevent short circuits, remove the key from the
ign&on and disconnect the (3 terminal OF the battery.
7. Make the proper Input and outpvt cable connectIons For
each unli.
3. Connect the wiring harness wires In the followq
order:
ground, battery, Ignition.
installation
surface.
Please avold Installation on uneven surfaces.
* Mount the unit so that the mountlny
angle IS 30" or
less.
@ Do not install the receiver unit under the carpet.
Othelwlse
heal build-up occurs and the unit may be
damaged.
4. Connect the wiring harness connector to the unit.
5. Install the LJIX': in your car
6. Reconnect the @ tsrmlnal of the battery
7. Press the resot button. (See p. 41
e If vour car's l~nltlon does not come with an KC
p&ion,
con&cl
the ignition wires to a power source
that can be turned on and off with the Ignltlon key. If
you connect the Ignition wire to a power source that
receives a constant voltage supply, as with battery
wires, the battery may die.
a If the fuse blows, first make sure that the wires have
not caused a short clrcult, then replace the old fuse
with one with the same rating.
* Do not lel unconnected
wires or terminals touch
melal on the car or anythlng else conducting
electricity.
To prevent short clrcu&s do not remove the
caps from unused iermlnals
or from the ends of the
unconnected
wires.
61 After the unll IS Installed, check whether thr? brake
lamps, blinkers, wipers, etc. on the car are working
properly.
e Insulate unconnected
wires with vlnyl Lape or other
slmllar material.
@Thoroughly wipe away 011 and other dirt From the
'8 Plug the vehicle's harness Into
3 ILock the cable clamp.
Press down using pliers until
the relay connector.
the conductive
metal is eveli
2 Pllrg the parking brake detectlon
with the plastrc surface.
wtre lnlo the relay connector.
5 Lock the lid.
Vehicle
harness
Advertisement
