Setting: Adjustment Of Booklet Stapling Position; Setting: Adjustment Of Center Folding Position - Kyocera KM-3050 Service Manual

2GN/2GP/2GR-2
Maintenance
item No.

Setting: adjustment of booklet stapling position

U246
Make sure that the center folding position is correct after adjustment. If the position is not correct, execute the
adjustment of center folding position.
1. Select the [STAPLE POS ADJ 1], [STAPLE POS ADJ 2] or [STAPLE POS ADJ 3].
2. Change the setting using the +/- or numeric keys.
Description
Adjustment of booklet stapling position for A4/letter size
Adjustment of booklet stapling position for B4/legal size
Adjustment of booklet stapling position for A3/ledger size -10 to 10
When staples are placed too far right (sample 1), decrease the preset value. When staples are placed
too far left (sample 2), increase the preset value.
Reference value: within
3. Press the start key. The value is set.
4. To return to the screen for selecting an item, press the stop key.

Setting: adjustment of center folding position

Check the booklet stapling position is correct before adjusting the center folding position.
1. Select the [BOOKLET POS ADJ1], [BOOKLET POS ADJ2] or [BOOKLET POS ADJ3].
2. Change the setting using the +/- or numeric keys.
Description
Adjustment of center folding position for A4/letter size
Adjustment of center folding position for B4R/legal size
Adjustment of center folding position for A3R/ledger size
When the centerfold position too far right (sample 1), increase the preset value. When the centerfold
position too far left (sample 2), decrease the setting value.
Reference value: within
3. Press the start key. The value is set.
4. To return to the screen for selecting an item, press the stop key.
1-3-60
±
2 mm
±
3 mm
Center line
Description
Setting
range
-10 to 10
-10 to 10
2 mm
Sample 1
Figure 1-3-22
Setting
range
-10 to 10
-10 to 10
-10 to 10
3 mm
Sample 1
Figure 1-3-23
Initial Change in
setting value per step
0 0.55 mm
0 0.55 mm
0 0.55 mm
2 mm
Sample 2
Initial Change in
setting value per step
0 0.55 mm
0 0.55 mm
0 0.55 mm
3 mm
Sample 2