Serial <X; Set Clock; Smtp Server Not Set Up. Contact System Administrator; Some Held Jobs Were Not Restored - Ricoh M126 Service Manual

Serial <x>
The printer is using a serial cable connection. The serial port is the active communication link.

Set clock

The clock is not set. This message appears if no other fax status message appears. It remains until the clock is set.

SMTP server not set up. Contact system administrator.

An error occurred on the SMTP server, or the SMTP server is not configured properly. Touch Continue to clear the
message. If the message appears again, contact your system support person.

Some held jobs were not restored

Touch Continue to delete the specified job.
Note: Some held jobs are not restored. They stay on the hard disk and are inaccessible.

System busy, preparing resources for job.

Not all resources needed for the job are available. Wait for the message to clear.

System busy, preparing resources for job. Deleting held job(s).

Not all resources needed for the job are available. Some held jobs are deleted to free system memory. Wait for the
message to clear.

Unsupported disk

An unsupported printer hard disk has been installed. Remove the unsupported device, and then install a supported
one.

Unsupported USB device, please remove

Remove the unrecognized USB device.

Unsupported USB hub, please remove

Remove the unrecognized USB hub.
USB/USB <x>
The printer is using a USB cable connection. The USB port is the active communication link.
Troubleshooting
255