Oce 4700 Series Installation Manual page 28

4730 model
Insert the Height Alignment Chart into the scanner and press
1
In Power Scan, select a Scan Width of 8.5 and press
2
When the horizontal lines have been prescanned press
3
Set the
4
view the lines clearly.
The
Detail
Use a small screwdriver to turn the screw through the hole on the front of the
5
scanner body (see figure 14) either clockwise or anti-clockwise until the
horizontal line is a continuous line:
Clockwise:
Anti-clockwise:
[15] Checking Camera Alignment
4740 model
To adjust the left camera (seen from front of scanner), follow same procedure
1
as for the 4730 model, but select a
from the left of the
hole.
To adjust the right camera, follow the above procedure, but select a
2
window centered about one-third in from the right of the
Use the screwdriver through the right hole.
28 4700 Series Scanners Installation Manual
window from the center of the
Detail
window should resemble one of the three as below.
Line on the right side of the screen moves down.
Line on the right side of the screen moves up.
Overview
Overview
window centered about one-third in
Detail
window. Use the screwdriver through the left
Paper Feed
to prescan.
Forward
.
Halt
window so that you can
HEIGHT ALIGNMENT CHART
PART NO. 6399A102
0
INSERT THIS EDGE AT
INSERT THE TEST CHART
WITH THIS SIDE DOWN
INSERT THIS EDGE
Detail
window.
Overview
.