Changing the power voltage
Your scanner power voltage has been preset to meet the 220 V requirements.
To change it to fit other national standards, proceed as follows:
Turn the scanner off and disconnect the power cable. Locate the power
1
assembly (
Open the voltage box (
2
Remove the fuse block (
3
Rotate the fuse block 90°, 180° or 270° so that the appropriate voltage appears
4
in the voltage aperture.
Put the voltage box back into its orinal position, reconnect the power cord and
5
turn the scanner on.
[13] Changing the Power Voltage
26
4700 Series Scanners Installation Manual
) at the back of the scanner.
A
) by lifting the plastic tab with the tip of a screwdriver.
B
).
C
A
C
B