Oce 4700 Series Installation Manual page 19

Power On Indicator (Orange LED)
This indicator lights up when the scanner is turned on.
Warm-Up Indicator (Red LED)
When the scanner is powered up, the Warm-Up indicator lights
up for 1 minute during which internal diagnostic checks are
carried out. The scanner cannot be activated during this phase.
Paper Feed Key and Scan-in-Progress indicator
You can now place your document face down along the edge of
the document insertion slot.
The document insertion slot is marked with a ruler from 0 to 8.5.
The divisions correspond to the Scan width setup in the Power
Scan software. See figure 3.2 and refer to the table on page 3-5.
Press the key: the document moves up to the start
Paper Feed
position. The indicator is now lit
Scan-in-Progress (Green LED)
continuously, i.e. the scanner is ready to receive instructions.
During scanning, the Scan-in-Progress indicator blinks on and off.
When scanning has finished, the Scan-in-Progress indicator is
continuously lit again. Press the Paper Feed key to eject the
document.
Pressing the Paper Feed key during scanning automatically stops
scanning and forwards the document through the scanner for as
long as you press key.
If you remove the document from the scanner manually,
Note:
the Scan-in-Progress Indicator stays on. Simply press the Paper
Feed key to reset it.
Paper Reverse key
When this key is pressed, scanning stops and the document is
reversed back through the scanner for as long as you press the
key.
Operation and Upkeep 19