Maintenance
Cleaning the scanning area
Clean the scanning area from time to time to remove any residual paper dust.
Switch the power Off and disconnect the power cord. Gently open the top
1
cover (
Holding the handles (
2
10, lift the guide plate up and away from the scanner. Place the guide plate on
the top cover.
Carefully wipe clean the glass plate and the white area on the guide plate with
3
a cleaning solution suitable for computer peripherals.
Put the guide plate back in its operating position as shown in figure 11. Hold
4
the handles (
Lower the guide plate into position.
[11] Replacing the Guide Plate
24
4700 Series Scanners Installation Manual
) as shown in figure 9 on page 23.
A
) at each end of the guide plate (
C
) up and position the vertical tabs (
C
) as shown in figure
B
) over the notches (
D
D
E
).
E