Buderus 600 - 11S Installation And Servicing Instructions page 29

Initial start-up
Remove multimeter and restore the plug-and-socket
connection to its original state.
Turn the chimney sweep switch to position "0".
Reconnect the system to the power supply.
When the display shows "7" and the service button is
pressed, the display turns to "c". Press the Reset button.
The display shows "r".
2.1.16 Handing over
After completing the installation and commissioning of the
system the installer should hand over to the householder by
the following actions:
Hand the User Manual to the householder and explain
his/her responsibilities under the relevant national
regulations.
Explain and demonstrate the lighting and shutting down
procedures.
The operation of the boiler and the use and adjustment of
all system controls should be fully explained to the
householder, to ensure the greatest possible fuel economy
consistent with the household requirements of heating.
Advise the User of the precautions necessary to prevent
damage to the system and to the building in the event of the
system remaining inoperative during frosty conditions.
Explain the function and the use of the boiler heating
controls.
Explain the function of the boiler fault mode. Emphasise
that if a fault is indicated, the boiler should be turned off and
a registered local heating installer consulted.
Explain and demonstrate the function of time and
temperature controls, radiator valves etc., for the economic
use of the system.
Loss of system water pressure
Explain that the dial on the control panel indicates the
central heating system pressure and that if the normal
COLD pressure of the system is seen to decrease over a
period of time then the systems needs to be topped up.
If the pressure decreases frequently than a registered local
heating installer should be consulted.
WARNING
Do not fire the boiler if the pressure has
reduced to zero from the original setting.
After installation, commissioning and customer handover
instructions please complete the BENCHMARK appliance
log book and leave this with the customer.
IMPORTANT
A comprehensive service should be carried out annually.
Stress the importance of regular servicing by a Corgi
registered installer.
Subject to modifications resulting from technical improvements!
Installation and maintenance instructions for wall-mounted condensing gas boiler 600 - 11S/19S/24S/24C • 05/2004
Boulter Buderus Ltd. • http://www.boulter-buderus.co.uk
2
29